This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility: A research team led by Professor Yang Dong from the Dalian Institute of Chemical Physics (DICP) of the Chinese Academy of Sciences (CAS), in collaboration with Dalian Jiaotong University, has developed a synergistic additive strategy for large-area slot-die coating of methylammonium-free (MA-free) perovskite films. The study is published in Advanced Materials.
Slot-die coating offers a promising route to industrial-scale perovskite solar cell production, owing to its high material utilization and compatibility with continuous roll-to-roll processing. The MA-free FAₓCs₁₋ₓPbI₃ system enables stable device operation by eliminating volatile methylammonium, but its slower intrinsic crystallization and stronger phase-segregation tendency complicate wet-film control and uniform crystallization during ambient-air coating and can also compromise film phase stability. To address these challenges, the team devised a synergistic additive strategy using formamidinium thiocyanate (FASCN) and rubidium thiocyanate (RbSCN).
The two additives play complementary roles: FASCN promotes nucleation induced by vacuum-flash treatment and subsequent crystal growth, whereas RbSCN helps stabilize the photoactive perovskite phase. Specifically, Rb⁺ occupies the A site of the perovskite lattice, relaxing lattice strain and lowering the activation energy for formation of the photoactive α-FAPbI₃ phase, thereby suppressing the formation of the non-photoactive δ-FAPbI₃ phase. Through these complementary effects, the team extended the processing window for uniform perovskite crystallization to more than 100 seconds.
The resulting films exhibit a dense microstructure, large grains, a uniform vertical compositional gradient and reduced residual stress. The small-area perovskite solar cells delivered a power conversion efficiency (PCE) of 26.16%. A large-area module with an active area of 54.80 cm² reached a PCE of 22.70%, substantially higher than the 15.8% of the control module.
The strategy also improved operational stability. Unencapsulated devices retained 97.76% of their initial efficiency after 1,300 hours of continuous maximum-power-point tracking under AM 1.5G illumination at 65°C; by comparison, control devices retained only 65.86% under the same conditions. Lianjie Duan et al., Processing Window Expansion Enables Uniform Crystallization in Scalable Ambient‐Fabricated Perovskite Photovoltaics, Advanced Materials (2026).
DOI: 10.1002/adma.75520 BA art history, MA material culture. Former museum editor, paramedic, and transplant coordinator. Editing for Science X since 2021.
Extract — continue reading at the source.
